|
4 Axes Low-Cost Motion Control Chip: MCX304 |
|
|
|
|
Page 2 of 3
Features - Independent control of 4-axes
- S-curve, trapezoidal or velocity contouring
- On the fly target position and velocity changes
- Maximum speed: 4MPPS, available for constant speed, linear/s-curve acceleration/deceleration driving
- Supports automatic deceleration including for non-symmetrical trapezoidal acceleration / deceleration driving
- Supports automatic home search that high-speed near home search - low-speed home search - encoder Z-phase search - offset drive
- Built-in integral type filter, selectable to enable or pass a signal through, and time constant from 8 types
- Selectable independent 2 pulse or 1 pulse/direction system
- 32-bit compare registers for each axis, can be used as software limit
- Read out of drive status by registers
- Selectable encoder input mode, quadrature or up/down pulse input
- Emergency stop input for all axes
- Connectable CMOS, TTL
- 100-pin QFP package 5V operation
Download (go directly to our Download Center; some downloads require registration and seperate login)
|
|
|
|
Newsflash
|
Motion Control Cards with Special PIEZO (Ceramic) Motor Functions Motion Control Chips with special functions to compensate PIEZO Motor behaviour Products Names: - POSYS® 1800-PIEZO Series
- POSYS® 1900-PIEZO Series
Description: The POSYS® 1800-PIEZO and POSYS® 1900-PIEZO are motion control cards (PC-104, PCI-bus) for servo and stepper motors and provide one to four axes of motion. The functionality of these series has been significantly improved by using a special motion control chip with enhanced PIEZO (Ceramic) control functions. It is now possible to compensate the special behaviour of PIEZO (Ceramic) motors like for example stiction. |
|
Read more...
|
|
|
| |
